top of page

Airpark Safety: Wind Socks, Tetrahedrons, Traffic Patterns and Shared Taxiways

1 day ago
3 min read

Most residential airparks are non-towered airports. Pilots coordinate with each other by radio on the common traffic advisory frequency (CTAF) and by flying predictable traffic patterns. On the ground, taxiways are often shared with cars, golf carts, bicycles, pets and children.

This guide covers how to read airpark wind indicators, fly a standard traffic pattern, and reduce risk on shared runways and taxiways. It is general information. Always follow current FAA guidance, your community's procedures and your training.

How to read airpark wind indicators

The FAA's Aeronautical Information Manual describes the wind and landing direction indicators you will see at many airparks (FAA AIM 4-3-4).

Wind cone (wind sock)

The wind cone shows wind direction and gives a sense of speed. The large end points into the wind. A fully extended sock suggests a stronger wind than one hanging limp.

Tetrahedron

A tetrahedron shows landing direction, not wind. Its small end points in the direction of landing. The FAA cautions pilots against using a tetrahedron to judge wind direction. In light or calm winds, it may not line up with the runway in use, so check the wind cone or other sources.

Segmented circle

A segmented circle is a ring of markers around the wind indicators. It can include landing strip indicators showing runway alignment and traffic pattern indicators showing which direction to turn for each runway.

Flying the traffic pattern at a non-towered airpark

Turn direction

At airports in Class G airspace, pilots of powered fixed-wing aircraft must make all turns to the left, unless approved light signals or visual markings show right turns (14 CFR 91.126). Check the segmented circle and published information for right-hand traffic.

Pattern altitude and entry

FAA guidance for non-towered airports recommends (FAA Advisory Circular 90-66C):

  • Propeller aircraft: 1,000 feet above the airport, unless the Chart Supplement publishes a different altitude

  • Turbine aircraft: 1,500 feet above the airport, or 500 feet above the propeller pattern altitude

  • Standard entry: a 45-degree angle to the downwind leg at pattern altitude

  • Midfield crossing: 500 feet above pattern altitude, then descend and enter

Radio calls

Self-announce your position and intentions on the CTAF when approaching, entering the pattern and departing, and listen before you talk. At a private airpark, ask the community for its frequency and procedures, which may add to FAA guidance.

Safety on shared taxiways

  • Taxi slowly, and use a wing walker in tight spots.

  • Know the right-of-way rules for aircraft, vehicles and pedestrians in your community.

  • Watch for fixed hazards like mailboxes, landscaping, fences and parked cars near the taxiway edge.

  • Shut down before crowded areas, and push or tow the aircraft into the hangar.

  • Treat every propeller as live. Make sure children and guests know this.

  • Use lights and beacons when starting and taxiing, so neighbors know an engine is running.

Residential airpark risk checklist

Communities can reduce risk with simple, shared practices:

  • Runway condition reports, and a clear way to close the runway (for example, X markers) during maintenance

  • Signs and markings where roads cross taxiways

  • Wildlife and obstruction control near runway ends and approach paths

  • Clear runway edges, with no vehicles, equipment or trash cans left near the runway

  • An emergency plan: who to call, the community's street address for 911, and how emergency vehicles reach the runway

  • A welcome packet for new residents and guests, with local procedures and noise rules

Plan before you fly to a new airpark

Most airparks are private property and require prior permission to land. Before flying in, call ahead, ask about runway condition and local procedures, and check current official sources. FAA data on AirparkMap is for reference only, never for flight planning or navigation.

Find runway facts for airparks by state on AirparkMap, including Arizona, Florida, Texas, California, Washington and Idaho. For more on how airparks work, read What Is an Airpark?

Frequently asked questions

Which way does a wind sock point?

The large end of a wind cone, or wind sock, points into the wind.

What does a tetrahedron show at an airport?

A tetrahedron shows the landing direction. Its small end points in the direction of landing. The FAA cautions pilots not to use it to judge wind direction, especially in light or calm winds.

What is the traffic pattern altitude at a non-towered airport?

FAA guidance recommends 1,000 feet above the airport for propeller aircraft and 1,500 feet for turbine aircraft, unless the Chart Supplement publishes a different altitude.

Can I land at any airpark?

No. Most airparks are private-use airports on private property, and visiting pilots need prior permission to land.

 
 
 

Comments


Commenting on this post isn't available anymore. Contact the site owner for more info.
bottom of page